Introduction

Use this guide to replace a faulty microphone unit in your Oregon Scientific Meep! X2 tablet.

Parts

No parts required.

Image 1/1:
  • Remove the orange covers from the left and right sides of the device by sliding up against the tabs.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • You can remove the rear casing by unscrewing all six phillips #00(3.5mm x 4.5mm)screws from the left and right side of the device.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Use the plastic opening tools to undo the clips around the edges of the device.

Add Comment

Image 1/2: Image 2/2:
  • Use your tweezers to gently remove the microphone from the slot in the casing.

Add Comment

Image 1/2: In the case of screen or screen sensor replacement, disregard desoldering steps. Image 2/2: In the case of screen or screen sensor replacement, disregard desoldering steps.
  • Unsolder the microphone unit from the motherboard using the soldering station.

  • In the case of screen or screen sensor replacement, disregard desoldering steps.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

J'mel Henneman

Member since: 01/20/2015

855 Reputation

8 Guides authored

Team

USF Tampa, Team 9-1, Blackwell Winter 2015 Member of USF Tampa, Team 9-1, Blackwell Winter 2015

USFT-BLACKWELL-W15S9G1

3 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 88