Fix Your Stuff Community Store

Olympus Stylus Tough TG-2 iHS Connector Port Casing Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

Introduction

Prerequisite Only

What you need

  1. Olympus Stylus Tough TG-2 iHS Connector Port Casing Replacement, Connector Port Casing: step 1, image 1 of 1

    • Locate the side of the camera with the connector cover.

    • Remove the 2 Phillips #00 4.6mm casing screws.

    Edit

  3. Olympus Stylus Tough TG-2 iHS Connector Port Casing Replacement: step 2, image 1 of 2 Olympus Stylus Tough TG-2 iHS Connector Port Casing Replacement: step 2, image 2 of 2

    • Open the connector cover by sliding the tab labeled lock to revile orange.

    • Slide the connector cover lock to revile orange and the door will spring open.

    • Remove the single internal Phillips #00 3.77mm screw.

    Edit

  4. Olympus Stylus Tough TG-2 iHS Connector Port Casing Replacement: step 3, image 1 of 3 Olympus Stylus Tough TG-2 iHS Connector Port Casing Replacement: step 3, image 2 of 3 Olympus Stylus Tough TG-2 iHS Connector Port Casing Replacement: step 3, image 3 of 3

    • Close the door to gain access to the casing.

    • Use your fingers to remove the black plastic casing that surrounds the connector door.

    • Use your fingers to remove the next black plastic piece .

    • Remove the two screws revealed

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 70