Olympus D590 Face Plate Replacement

Step 1 Face Plate

• Flip camera so you are looking at the bottom.
• Unscrew all 5 base plate screws.
Step 2

• Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
Step 3
• Unscrew the single screw located next to the battery slot.
Step 4
• Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
• Lift the rubber plate exposing the ports beneath.
Step 5
• Unscrew the 2 screws next to the USB and AC ports.
Step 6
• Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
Step 7
• Pull off the faceplate to reveal the inside of the camera.
• Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

Author

with 11 other contributors

Katie

Member since: 04/15/10

31 Reputation

3 Guides authored

Badges: 7

• 
• 
• 

+4 more badges

Team

Cal Poly, Team 28-23, Regan Spring 2010 Member of Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 Members

14 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview