Introduction

Using this guide, users will be able to replace the cooling vent of their blender.

Remove the cup from the blender base.
  • Remove the cup from the blender base.

Add Comment

Turn the blender over and unscrew the three 14 mm screws holding the slotted base in place. These are Torx Security bits (TR9) on some units.
  • Turn the blender over and unscrew the three 14 mm screws holding the slotted base in place. These are Torx Security bits (TR9) on some units.

The three screws holding the slotted base in place on some units are Torx Security bits (TR9) not phillips. The tool is listed above (T9 Torx Screwdriver is actually a TR9 Torx Security Screwdriver . It’s the right tool.

Dennis Carr - Reply

  • Using a the standard Phillips head screwdriver bit, remove the slotted black plastic covering and then unscrew the one 11mm screw holding the power cord in place.

  • Unscrew the four 14 mm screws that are in the deep slots. This will release the motor from the base.

Add Comment

  • CAUTION: the silver blade attached to the motor is very sharp. Use a towel or thick cloth to protect your hands for the next step.

  • Using a towel, hold the silver fan still. Twist the small black rubber wheel that is attached to the top of the blender base to the right. This will remove the wheel for replacement.

Add Comment

  • Slide the cooling vent out from the silver plastic part of the blender base and replace it.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Morgan Blauth

Member since: 02/24/2016

696 Reputation

5 Guides authored

Team

USF Tampa, Team 1-5, Leahy Spring 2016 Member of USF Tampa, Team 1-5, Leahy Spring 2016

USFT-LEAHY-S16S1G5

2 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 6

All Time: 302