Introduction

Replacing the speaker on a NuVision TM1088 is a fairly simple process, but will require some soldering.

Parts

No parts required.

Place the plastic opening tool between the front and rear cover and pry up on each corner of the cover.
  • Place the plastic opening tool between the front and rear cover and pry up on each corner of the cover.

Add Comment

Melt the solders with a heat gun and remove red and black wires.
  • Melt the solders with a heat gun and remove red and black wires.

Add Comment

Peel the speaker off the rear cover.  It is only held in by a small amount of glue.
  • Peel the speaker off the rear cover. It is only held in by a small amount of glue.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nathaniel Nasman

Member since: 03/23/2015

603 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 7

All Time: 433