Introduction

This replacement guide shows how to change the heating coils.

First, Remove the two Phillips #2 head screws (1.3 mm). Next, using Spanner S6 tool, remove the Spanner Screw.
  • First, Remove the two Phillips #2 head screws (1.3 mm).

    • Next, using Spanner S6 tool, remove the Spanner Screw.

    • Carefully place somewhere safe these three screws to use later to assemble back.

Add Comment

Split the device in half to expose the internal parts of the device.
  • Split the device in half to expose the internal parts of the device.

  • Again, there are two more Phillips screws to remove.

Add Comment

Remove the two screws from both sides of the heating coil.
  • Remove the two screws from both sides of the heating coil.

Add Comment

Replace the heating pan, & you done with replacement.
  • Replace the heating pan, & you done with replacement.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Xingdi Zhou

Member since: 06/27/2017

466 Reputation

3 Guides authored

Team

UW Tacoma, Team S1-G4, Liner Summer 2017 Member of UW Tacoma, Team S1-G4, Liner Summer 2017

UWT-LINER-SU17S1G4

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 96