Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

How to disassemble the device and change broken, smashed LCD display and Touch screen digitizer Glass.


Video Overview

  1. Switch off the phone. Remove the battery and any installed SIM and memory cards. Remove the black tape near to the loudspeaker.
    • Switch off the phone.

    • Remove the battery and any installed SIM and memory cards.

    • Remove the black tape near to the loudspeaker.

  2. Remove the 9x Torx T4 screws. Two of them are with the same head size but with a different length. Two of them are with the same head size but with a different length.
    • Remove the 9x Torx T4 screws.

    • Two of them are with the same head size but with a different length.

  3. Use a plastic opening tool to remove the back cover. Careful unhook the display assembly flex cable. Careful unhook the display assembly flex cable.
    • Use a plastic opening tool to remove the back cover.

    • Careful unhook the display assembly flex cable.

  4. Put some scotch tape to prevent the glass from scattering. Use a hot gun or hair dryer and warm the glass to soften the adhesive.
    • Put some scotch tape to prevent the glass from scattering.

    • Use a hot gun or hair dryer and warm the glass to soften the adhesive.

  5. Start the separating from the upper right corner, where you have an hole in the middle frame. Use plastic tool to prevent the middle frame from scratches. Work slowly, you can cut your fingers.
    • Start the separating from the upper right corner, where you have an hole in the middle frame.

    • Use plastic tool to prevent the middle frame from scratches.

    • Work slowly, you can cut your fingers.

  6. Clean the middle farme. Put adhesive tape 3MM. Be careful, don't cover the technological openings on the middle frame (for the light sensor, earpiece, etc.).
    • Clean the middle farme.

    • Put adhesive tape 3MM.

    • Be careful, don't cover the technological openings on the middle frame (for the light sensor, earpiece, etc.).

    • It's easier if you order the spare part together with an adhesive tape.

    • Install the display assembly.

  7. That's all. .
    • That's all.

    • .

    • .

    • .

    • .

    • .

    • .

    • Did you do it successfully?

ZFix

Member since: 12/09/2013

166,806 Reputation

305 Guides authored

Team

Master Techs Member of Master Techs

Community

288 Members

822 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 12

Past 30 Days: 41

All Time: 8,723