1. Check condition of switches on logicboard
    • Check condition of switches on logicboard

    • Rule out failure of cover

    Add Comment

  2. Torx 6 screwdriver
    • Torx 6 screwdriver

    • Soldering iron (thin tip)

    • Decent quality solder (thin wire)

    Add Comment

    • Remove cover, battery and SIM

    • Remove 6 torx screws

    • Note: Green is fine thread

    • Note: Red is coarse thread

    Add Comment

    • Remove plastic clover near battery

    • Keep track of all parts

    Add Comment

    • Gently release logicboard connectors

    Add Comment

    • There is a clip that needs to be moved out of the way before the board will move.

    • Start by lifting long side of logicboard

    • Gently wiggle and lift

    • Undo plastic clips near battery with force

    Add Comment

    • Check connections of failed buttons

    Add Comment

    • Resolder broken connections

    • Make sure the pads do not short

    Add Comment

    • Put back logicboard

    • Make sure pins near camera line-up

    • Note: Plastic clips need quite some force

    Add Comment

    • Reconnect logicboard connectors

    Add Comment

    • Put back plastic cover

    Add Comment

    • Gently tighten screws

    • Put back SIM card and battery

    • Close cover

    • Enjoy the result ;)

    Add Comment

Finish Line

11 other people completed this guide.

Anne

Member since: 10/17/2014

456 Reputation

1 Guide authored

4 Comments

Realmente funcionó el tutorial, sirven de nuevo los dos botones que fallaban.

Gaia501 - Reply

Only the 2 middle screws are fine threaded. And you can see in the pictures here, that there are 4 coarse threaded ones and 2 fine threaded ones. The green one in the corner should be red

shadow118 - Reply

hafıza kart okuyucu çalışmıyor ne yapmam lazım

davutcigir - Reply

Omg it looks complicated

Maz Hanvey - Reply

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 10

Past 30 Days: 24

All Time: 9,440