Introduction

With this guide we will help you, if you want to disassemble the phone and replace the Digitizer / Glass or the LCD Display. Also this guide is useful for replacing Loudspeaker, Earpiece, Front camera, etc.


Before ordering the new Touch screen check the revision (you can see it on the digitizer flex cable, near to the connector).


__________________________ Video manual: __________________________

Video Overview

Switch off the phone, remove the battery and SIM (Memory) card. The lower back cover is held by 3x T4 Torx screws. The screws are of two types!
  • Switch off the phone, remove the battery and SIM (Memory) card.

  • The lower back cover is held by 3x T4 Torx screws.

  • The screws are of two types!

Add Comment

Loudspeaker Touch screen flex cable connector
  • Loudspeaker

  • Touch screen flex cable connector

  • LCD Display flex cable connector

Add Comment

If you want to replace the Digitizer, let's test the spare part first. Be careful, don't break the flex cable. Be careful, don't break the flex cable.
  • If you want to replace the Digitizer, let's test the spare part first.

  • Be careful, don't break the flex cable.

Add Comment

Another three screws hold the Upper Back Cover. Disconnect the Touch screen and the Digitizer flex cables. Disconnect the Touch screen and the Digitizer flex cables.
  • Another three screws hold the Upper Back Cover.

  • Disconnect the Touch screen and the Digitizer flex cables.

Add Comment

If you have not yet disconnected the Digitizer and the Touch screen flex cables, do it now. The Logic Board is held to the Middle frame by two plastic clips.
  • If you have not yet disconnected the Digitizer and the Touch screen flex cables, do it now.

  • The Logic Board is held to the Middle frame by two plastic clips.

Add Comment

With a plastic tool gently release the mother board and remove it. With a plastic tool gently release the mother board and remove it. With a plastic tool gently release the mother board and remove it.
  • With a plastic tool gently release the mother board and remove it.

Add Comment

Front Camera and Proximity & Light sensor module Earpiece Remove them one by one.
  • Front Camera and Proximity & Light sensor module

  • Earpiece

  • Remove them one by one.

Add Comment

The Midle frame is held by 6x locking clips, three on each side. Release them and remove the Middle frame. The Midle frame is held by 6x locking clips, three on each side. Release them and remove the Middle frame. The Midle frame is held by 6x locking clips, three on each side. Release them and remove the Middle frame.
  • The Midle frame is held by 6x locking clips, three on each side. Release them and remove the Middle frame.

Add Comment

Now gently remove the LCD Display. If you have a broken LCD, replace it and reassemble the phone. We will continue with removing the Touch screen Glass.
  • Now gently remove the LCD Display.

  • If you have a broken LCD, replace it and reassemble the phone.

  • We will continue with removing the Touch screen Glass.

Add Comment

Put a scotch tape to prevent the glass from scattering. With a hot air warm the glass to soften the adhesive. You can use a hair dryer for this operation.
  • Put a scotch tape to prevent the glass from scattering.

  • With a hot air warm the glass to soften the adhesive.

  • You can use a hair dryer for this operation.

  • Start with separating at the middle, where the bonded area is smaller.

Add Comment

Continue with the separation by using a plastic tool. Continue with the separation by using a plastic tool. Continue with the separation by using a plastic tool.
  • Continue with the separation by using a plastic tool.

Add Comment

Clean the remnants of the old adhesive tape. If the spare parts come without adhesive tape, you must put by himself. Prepare the new digitizer glass and install it.
  • Clean the remnants of the old adhesive tape.

  • If the spare parts come without adhesive tape, you must put by himself.

  • Prepare the new digitizer glass and install it.

  • Reassemble the device.

Add Comment

That's all.
  • That's all.

  • .

  • .

  • .

  • .

  • .

  • .

  • Did you do it successfully?

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

9 other people completed this guide.

ZFix

Member since: 12/09/2013

131,986 Reputation

388 Guides authored

Team

Master Techs Member of Master Techs

Community

266 Members

635 Guides authored

One Comment

great guide! I made it quite easily, thanks so much

tave - Reply

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 27

Past 30 Days: 164

All Time: 7,063