Introduction

Replacing the charger connector.

Press the grip on the back of the phone and slide the rear housing down towards the bottom of the phone. Press the grip on the back of the phone and slide the rear housing down towards the bottom of the phone. Press the grip on the back of the phone and slide the rear housing down towards the bottom of the phone.
  • Press the grip on the back of the phone and slide the rear housing down towards the bottom of the phone.

Add Comment

Use your fingernail and gently pull the the bottom of the battery up. Lift out battery and remove. Lift out battery and remove.
  • Use your fingernail and gently pull the the bottom of the battery up.

  • Lift out battery and remove.

Add Comment

Use your fingernail to lift the metal cage up. Remove SIM card. Remove SIM card.
  • Use your fingernail to lift the metal cage up.

  • Remove SIM card.

Add Comment

Close the metal cage.
  • Close the metal cage.

Add Comment

Pull the top casing up after inserting thumbs under the two tabs labeled with the arrows. then slowly rotate up and over the screen. Pull the top casing up after inserting thumbs under the two tabs labeled with the arrows. then slowly rotate up and over the screen. Pull the top casing up after inserting thumbs under the two tabs labeled with the arrows. then slowly rotate up and over the screen.
  • Pull the top casing up after inserting thumbs under the two tabs labeled with the arrows. then slowly rotate up and over the screen.

Add Comment

After removing the top cover, turn the phone over so the screen is facing upwards. After removing the top cover, turn the phone over so the screen is facing upwards.
  • After removing the top cover, turn the phone over so the screen is facing upwards.

Add Comment

Lift the front off the phone by pulling above the arrows. Lift the front off the phone by pulling above the arrows. Lift the front off the phone by pulling above the arrows.
  • Lift the front off the phone by pulling above the arrows.

Add Comment

Remove the six screws with a T-6 Torx screwdriver. Remove the six screws with a T-6 Torx screwdriver. Remove the six screws with a T-6 Torx screwdriver.
  • Remove the six screws with a T-6 Torx screwdriver.

Add Comment

Lift the logic board and screen from the top. Be careful of loose parts. Be careful of loose parts.
  • Lift the logic board and screen from the top.

  • Be careful of loose parts.

Add Comment

Insert the screwdriver below the charger connector and press down to pry out. The charger connector should pop out with a slight push inwards with your thumb. The charger connector should pop out with a slight push inwards with your thumb.
  • Insert the screwdriver below the charger connector and press down to pry out.

  • The charger connector should pop out with a slight push inwards with your thumb.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Spencer Woodworth

Member since: 04/14/2010

247 Reputation

17 Guides authored

Team

Cal Poly, Team 23-63, Johann Spring 2010 Member of Cal Poly, Team 23-63, Johann Spring 2010

CPSU-JOHANN-S10S23G63

3 Members

17 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 25

All Time: 4,162