Introduction

This guide will demonstrate how to remove the plastic vent.

Parts

No parts required.

Unscrew the  Phillips #0 11mm screws. Unscrew the Torx Security #10 11mm screw. Unscrew the Torx Security #10 11mm screw.
  • Unscrew the Phillips #0 11mm screws.

  • Unscrew the Torx Security #10 11mm screw.

Add Comment

Unscrew the six Phillips #2 11mm screws from the remainder of the bottom plate. Pull the bottom covering off of the blender.
  • Unscrew the six Phillips #2 11mm screws from the remainder of the bottom plate.

  • Pull the bottom covering off of the blender.

Add Comment

Unscrew the two Phillips #2 9mm screws. Remove the plastic block.
  • Unscrew the two Phillips #2 9mm screws.

  • Remove the plastic block.

Add Comment

Unscrew the four Phillips #2 11mm screws. Remove the plastic covers. Removing the top cover and then rotating the bottom cover into the same orientation works best.
  • Unscrew the four Phillips #2 11mm screws.

  • Remove the plastic covers.

  • Removing the top cover and then rotating the bottom cover into the same orientation works best.

Add Comment

Unscrew the three Phillips #2 9mm screws.
  • Unscrew the three Phillips #2 9mm screws.

  • This metal plate doesn't need to be completely removed, just adjusted to the side to continue working.

Add Comment

Unscrew the four Phillips #2 11mm screws. Pull the power cord through as shown to create slack. Remove plastic casing by lifting upwards.
  • Unscrew the four Phillips #2 11mm screws.

  • Pull the power cord through as shown to create slack.

  • Remove plastic casing by lifting upwards.

Add Comment

Follow the power plug cords to find the right plastic caps. Squeeze the caps with pliers to loosen the grip. Pull the plastic caps off the twisted wires.
  • Follow the power plug cords to find the right plastic caps.

  • Squeeze the caps with pliers to loosen the grip.

  • Pull the plastic caps off the twisted wires.

Add Comment

Untwist the two wires from each other and  pull the zip tie off. Untwist the two wires from each other and  pull the zip tie off. Untwist the two wires from each other and  pull the zip tie off.
  • Untwist the two wires from each other and pull the zip tie off.

Add Comment

Unscrew the 2 Phillips #2 9mm screws.
  • Unscrew the 2 Phillips #2 9mm screws.

Add Comment

Grip the vent on either side and lift  it straight in the upward direction.
  • Grip the vent on either side and lift it straight in the upward direction.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ryan James Gilroy

Member since: 09/27/2017

301 Reputation

3 Guides authored

Team

Cal Poly, Team S9-G4, Banghart Fall 2017 Member of Cal Poly, Team S9-G4, Banghart Fall 2017

CPSU-BANGHART-F17S9G4

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 29