Introduction

If there is a power problem, you may need to reattach wires to the battery compartment or replace it completely. If the problem is Corrosion, just see the guide on corrosion.

  • In this guide we will be referring to 'left' and 'right' as though the camera's front (the part that says Nikon) is facing you.

  • Unscrew the large metal screw on the left side using a quarter and remove the battery cover.(Picture not available)

Add Comment

Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.
  • Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.

Add Comment

Pull up on the tab to remove the batteries.
  • Pull up on the tab to remove the batteries.

  • Note: The batteries will probably fall out of their holder.

Add Comment

Use a 00 Phillips head screwdriver to remove the four screws from inside the case.
  • Use a 00 Phillips head screwdriver to remove the four screws from inside the case.

Add Comment

Remove the battery compartment from the camera.
  • Remove the battery compartment from the camera.

  • Note: On some models, the compartment is soldered in by the wires shown. If so you will need to desolder them.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Zachary Phillips

Member since: 04/08/2011

178 Reputation

5 Guides authored

Team

Cal Poly, Team 25-26, Garner Spring 2011 Member of Cal Poly, Team 25-26, Garner Spring 2011

CPSU-GARNER-S11S25G26

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 21

Past 30 Days: 118

All Time: 8,355