Introduction

  1. You will need a #00 phillip's head screwdriver and a black spudger (or equivalent tool)

Parts

No parts required.

  1. Turn over camera to find 5 apparent screws.
    • Turn over camera to find 5 apparent screws.

  2. Remove all 5 screws from the bottom of the camera and store them carefully.
    • Remove all 5 screws from the bottom of the camera and store them carefully.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Open battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever. Remove this screw.
    • Open battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever. Remove this screw.

  5. Rotate camera to find side panel with lanyard attachment. Detach side panel by lifting bottom corner slightly with the spudger.
    • Rotate camera to find side panel with lanyard attachment. Detach side panel by lifting bottom corner slightly with the spudger.

  6. Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.
    • Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.

  7. With back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.
    • With back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Ryan

Member since: 04/12/2011

131 Reputation

6 Guides authored

Team

Cal Poly, Team 18-24, Garner Spring 2011 Member of Cal Poly, Team 18-24, Garner Spring 2011

CPSU-GARNER-S11S18G24

4 Members

6 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 1,167