Introduction

Follow these first three steps to accomplish the next guides.

Parts

No parts required.

Remove 8-2.46 mm screws from both sides and bottom of camera using a #000 Phillips screwdriver. Remove 2 screws from left side. (picture 1) Remove 4 screws from bottom. (picture 2)
  • Remove 8-2.46 mm screws from both sides and bottom of camera using a #000 Phillips screwdriver.

    • Remove 2 screws from left side. (picture 1)

    • Remove 4 screws from bottom. (picture 2)

    • Remove 2 screws from right side. (picture 3)

New Battery = Faster iPhone
Fix Kits starting at $16.99
Remove black cover pulling up with left thumb. Hold silver cover with right thumb. Remove silver cover lifting up with left thumb. Hold the camera with right thumb.
  • Remove black cover pulling up with left thumb. Hold silver cover with right thumb.

  • Remove silver cover lifting up with left thumb. Hold the camera with right thumb.

  • Once internal circuit board is exposed, the red and blue wire terminals at top center can provide a nasty shock from the charged flash capacitor (silver can to left of terminals). BE CAREFUL!

Remove 2-2.10mm screws in the front of the camera using a #000 Phillips screwdriver. Remove the two screws.
  • Remove 2-2.10mm screws in the front of the camera using a #000 Phillips screwdriver.

    • Remove the two screws.

  • Gently pull up to detach the frame. (picture 2)

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Jorge

Member since: 03/11/2015

1,092 Reputation

7 Guides authored

Team

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 582