Introduction

This guide will outline how to remove a dead battery, as well as how to properly install a new one.

Tools

No tools required.

    • At the top of the camera, turn the Mode dial to OFF.

  1. Lay the top of the camera down on a flat surface so that the informational tag and battery compartment are accessible.
    • Lay the top of the camera down on a flat surface so that the informational tag and battery compartment are accessible.

    • To open the battery compartment, push the latch underneath the word BATTERY to the left.

  2. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  3. Lift the battery compartment cover and remove the old battery.
    • Lift the battery compartment cover and remove the old battery.

  4. Insert the new battery as shown on the underside of the compartment lid.
    • Insert the new battery as shown on the underside of the compartment lid.

  5. Flip the battery compartment lid closed and push the latch to the right.
    • Flip the battery compartment lid closed and push the latch to the right.

    • Flip the camera so that the bottom rests on the table.

    • Turn the Mode dial to [A] to verify that the control panel shows a full power indicator.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cory Layman

Member since: 10/04/2011

89 Reputation

3 Guides authored

Team

UW Stout, Team 1-5, Zhou Fall 2011 Member of UW Stout, Team 1-5, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G5

5 Members

3 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 1,465