Introduction

These step by step instructions will allow you to easily remove the LCD screen on the watch and replace it with a new one.

Image 1/1:
  • First, place the watch upside down so the back of the watch is exposed. Unscrew the six size #000 5 mm long screws located on the back panel using a size 000 Phillips head screwdriver.

Add Comment

Image 1/1:
  • Carefully separate the watch by pulling the band away from the main board.

Add Comment

Image 1/1:
  • Then, unscrew the two main board size #000 2.5 mm long screws using a size 000 Phillips head screwdriver.

Add Comment

Image 1/1: Make sure to be gentle so the ribbon cable that connects to the band does not break, it is fragile and is not removable.
  • Carefully use the blue plastic opening tool to pry the main board out of the front panel.

  • Make sure to be gentle so the ribbon cable that connects to the band does not break, it is fragile and is not removable.

Add Comment

Image 1/1:
  • Use the blue plastic removal tool once again to carefully remove the screen.

Add Comment

Image 1/1:
  • Pull the plastic piece that is highlighted in the picture out from the back of the screen.

Add Comment

Image 1/1:
  • For reassembly, make sure the highlighted area in the picture, goes over the black plastic piece that was removed in the previous step.

Hello,

Thanks a lot for these informations. I would like to know how the LCD is maintained (glue, clip ???) Carine D

Carine Daudu - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Zainab Hussein

Member since: 10/27/2015

207 Reputation

1 Guide authored

Team

3 Comments

Hello, I found your article very interesting, I was just wondering do you know where I can buy a replacement screen?

Thank you

Joseph Kermani - Reply

hello do you know where I can find a replacement screen ?

Thank you

SMOUN - Reply

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 32

Past 30 Days: 106

All Time: 1,901