Introduction

This repair might be needed if your NikePlus Sportband screen has been damaged due to being drop or stepping on the device.

Parts

No parts required.

To begin the disassembly of your NikePlus Sportband, first remove the device from the rubber wristband. To begin the disassembly of your NikePlus Sportband, first remove the device from the rubber wristband.
  • To begin the disassembly of your NikePlus Sportband, first remove the device from the rubber wristband.

Add Comment

Finish the disassembly of your NikePlus Sportband by utilizing the metal spudger tool on the short edge to pry the external body pieces apart. Finish the disassembly of your NikePlus Sportband by utilizing the metal spudger tool on the short edge to pry the external body pieces apart.
  • Finish the disassembly of your NikePlus Sportband by utilizing the metal spudger tool on the short edge to pry the external body pieces apart.

Add Comment

Deck the Halls
With tools and Fix Kits
After the cover had been removed, use the metal spudger tool to remove the body of the device from the casing. After the cover had been removed, use the metal spudger tool to remove the body of the device from the casing.
  • After the cover had been removed, use the metal spudger tool to remove the body of the device from the casing.

Add Comment

Use the metal tweezers to pry the screen casing from the body of the device. The screen casing is fastened to the body  of the device by four clips located in each corner of the casing. The screen casing is fastened to the body  of the device by four clips located in each corner of the casing.
  • Use the metal tweezers to pry the screen casing from the body of the device.

  • The screen casing is fastened to the body of the device by four clips located in each corner of the casing.

Add Comment

Flip the body of the device over so that the screen is now on the bottom. The display ribbon cable is soldered to the motherboard. We were able to peel up the ribbon cable with a pair of tweezers.
  • Flip the body of the device over so that the screen is now on the bottom.

  • The display ribbon cable is soldered to the motherboard. We were able to peel up the ribbon cable with a pair of tweezers.

    • Successfully resoldering this ribbon cable to the motherboard may prove difficult to the very small traces.

Add Comment

Flip the body of the device back over so that the screen is facing up. Using the tweezers, gently lift the screen from body of the device. Using the tweezers, gently lift the screen from body of the device.
  • Flip the body of the device back over so that the screen is facing up.

  • Using the tweezers, gently lift the screen from body of the device.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Daniel Burtner

Member since: 02/15/2016

101 Reputation

1 Guide authored

Team

IUPUI, Team 9-9, Wilson Spring 2016 Member of IUPUI, Team 9-9, Wilson Spring 2016

IUPUI-WILSON-S16S9G9

5 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 104