Introduction

This guide details how to remove the camera's case.

Parts

No parts required.

Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.
  • Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.

make sure to add commas.

Step 1- remove the 8, 6mm...

Step 2- Using a philips head screwdriver, remove the 6, 4mm screws...

Same thing with step 6. Good page!

Jesica Bartell - Reply

Remove the butterfly nut from the lid arm.
  • Remove the butterfly nut from the lid arm.

Add Comment

Black Friday
Broken doesn't stand a chance.
Remove the lid-covering.
  • Remove the lid-covering.

Add Comment

Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.
  • Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.

Add Comment

Gently separate the two halves of the case.
  • Gently separate the two halves of the case.

  • The two halves are connected by a wire. Pulling too roughly can damage the wires and cause the camera to stop functioning.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sean Hill

Member since: 01/29/2015

434 Reputation

4 Guides authored

Team

UW Tacoma, Team 3-7, Rose Winter 2015 Member of UW Tacoma, Team 3-7, Rose Winter 2015

UWT-ROSE-W15S3G7

3 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 69