Introduction

The Baby Unit Microphone is vital because it allows you to communicate between the two monitors in different rooms. You will need a soldering kit to successfully install a new microphone.

  1. Using precision tweezers, remove the four rubber feet from the bottom of the baby unit. Using a Phillips #1 screwdriver, remove the 9.5mm screws that were under the rubber feet. Open the base of the baby unit.
    • Using precision tweezers, remove the four rubber feet from the bottom of the baby unit.

    • Using a Phillips #1 screwdriver, remove the 9.5mm screws that were under the rubber feet.

    • Open the base of the baby unit.

  2. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  3. Desolder the wires connecting the microphone to the circuit board. Beware of overheating, the soldering kit is capable of damaging the circuit board.
    • Desolder the wires connecting the microphone to the circuit board.

    • Beware of overheating, the soldering kit is capable of damaging the circuit board.

    • Beware of the potential for personal injury from heated metals.

    • For soldering procedures please refer to iFixit's guide to Soldering Skills.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

0 Comments

View Statistics:

Past 24 Hours: 4

Past 7 Days: 19

Past 30 Days: 52

All Time: 635