Introduction

Use this guide to replace a dead or dying battery for your Motorola Droid Turbo 2.

  1. Using your fingers, carefully remove the black tape from the battery.
    • Using your fingers, carefully remove the black tape from the battery.

    • Try not to rip the tape as you will use it on the new battery.

    Add Comment

  2. Remove two 4.0 mm T4 Torx screws securing the metal battery bracket.
    • Remove two 4.0 mm T4 Torx screws securing the metal battery bracket.

    • Remove the metal bracket.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use the angled tweezers to disconnect the small connector near the bottom right corner of the battery.

    Add Comment

    • Using a plastic opening tool, unlatch the small black ribbon on the upper right corner of the battery.

    Add Comment

    • Reheat the iOpener and apply it to the battery to help soften the adhesive holding it to the display assembly.

    • Use an old credit card, opening pick, or other flat plastic pry tool to carefully pry out the battery from the adhesive holding it in place.

    • Don't deform or puncture the battery, or it may leak dangerous chemicals or catch fire.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Chisi Amanda Xiong

Member since: 10/26/2016

537 Reputation

1 Guide authored

Team

UW Tacoma, Team 1-6, Rose Fall 2016 Member of UW Tacoma, Team 1-6, Rose Fall 2016

UWT-ROSE-F16S1G6

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 14

All Time: 63