Introduction

The flashbulb and casing are one component located at the top of the camera. A replacement will be the whole component and not each of the parts separately.

Parts

No parts required.

Locate and remove the silver screws on each side of the camera. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.
  • Locate and remove the silver screws on each side of the camera.

  • Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.

Add Comment

Then, carefully pry apart the front and back outer casing away from the internal components. Be aware of the ribbon wire that will disconnect when the casing is detached. Be aware of the ribbon wire that will disconnect when the casing is detached.
  • Then, carefully pry apart the front and back outer casing away from the internal components.

  • Be aware of the ribbon wire that will disconnect when the casing is detached.

Add Comment

Black Friday
Broken doesn't stand a chance.
Remove 2mm screws connecting the flash housing to the main components of the camera. Use a Philips #00 screwdriver to remove the black 2.0mm (4 instances) screws .
  • Remove 2mm screws connecting the flash housing to the main components of the camera.

  • Use a Philips #00 screwdriver to remove the black 2.0mm (4 instances) screws .

Add Comment

Use the spudger to push the black plastic hooks through the circuit board to release the flash housing. Once the screws have been removed, pull the circuit board away from the body of the camera. Wires will keep it from completely detaching.
  • Use the spudger to push the black plastic hooks through the circuit board to release the flash housing.

  • Once the screws have been removed, pull the circuit board away from the body of the camera.

  • Wires will keep it from completely detaching.

  • Pull the housing away from the circuit board.

Add Comment

Conclusion

To reassemble device, follow steps in reverse order. This will require the reattachment of wires from the camera to the flashbulb casing.

Keith Sechrist

Member since: 03/11/2013

1 Reputation

2 Guides authored

Team

Clemson, Team 12-4, Benson Spring 2013 Member of Clemson, Team 12-4, Benson Spring 2013

CLEM-BENSON-S13S12G4

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 279