Introduction
It will be necessary to solder the wire connection in order to properly complete this installation.
What you need
-
-
Remove the old or broken circuit board from the front case by carefully separating it from the back.
-
Clip the red and black wires at the base of the motherboard to completely separate it from the radio case. You should have 2 separate pieces.
-
-
-
-
Reattach the speaker wires and antenna to the new circuit board using a soldering iron. Take caution when using the hot soldering tool!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
Cal Poly, Team 19-43, Regan Winter 2013 Member of Cal Poly, Team 19-43, Regan Winter 2013
CPSU-REGAN-W13S19G43
3 Members
9 Guides authored
