Introduction

The back cover of the device keeps all the components safe from damage and must be removed for any component to be replaced in the device. The back cover is held on by screws and is very easy to remove.

Image 1/3: Remove the six 5mm Phillips #00  screws from the back of device. Image 2/3: Remove the six 5mm Phillips #00  screws from the back of device. Image 3/3: Remove the six 5mm Phillips #00  screws from the back of device.
  • Power off the Magellan RoadMate before beginning.

  • Remove the six 5mm Phillips #00 screws from the back of device.

Add Comment

Image 1/3: Do not fully open the back cover or you risk damaging the speaker wire. Image 2/3: Use a spudger to disconnect the speaker connection from the motherboard. Image 3/3: Use a spudger to disconnect the speaker connection from the motherboard.
  • Pry back cover off with a plastic opening tool just enough to see where the speaker is attached to the motherboard.

  • Do not fully open the back cover or you risk damaging the speaker wire.

  • Use a spudger to disconnect the speaker connection from the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Chris Blaskowski

Member since: 10/08/2016

358 Reputation

3 Guides authored

Team

IUPUI, Team 4-4, Wilson Fall 2016 Member of IUPUI, Team 4-4, Wilson Fall 2016

IUPUI-WILSON-F16S4G4

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 57