Magellan RoadMate 1200 Motherboard Replacement

Introduction

This guide will outline how to replace a Magellan RoadMate 1200 motherboard. This piece is an integral part to the system, and may malfunction or break after a long period of use.

What you need

Step 1 Back Cover

Magellan RoadMate 1200 Motherboard Replacement, Back Cover: step 1, image 1 of 2

Magellan RoadMate 1200 Motherboard Replacement, Back Cover: step 1, image 2 of 2

Remove the four rubber caps from the back by using the Phillips #00 screwdriver.

Edit

Step 2

Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.

Edit

Step 3

Remove the back cover from the device by separating the back cover along its seam.
Slowly lift the cover—the speaker is screwed onto the back cover and is connected to the circuit board.

Edit

Step 4

Pull the speaker cord, horizontally, by its base, away from the motherboard.
When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

Edit