Introduction

Removing the FightPad's front case for replacing the case or front artwork.

Use tweezers to completely remove the sticker from the rear of controller.
  • Use tweezers to completely remove the sticker from the rear of controller.

Add Comment

Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
  • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

Add Comment

Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases. Use the plastic opening tool to pry the two cases apart.
  • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

  • Use the plastic opening tool to pry the two cases apart.

Add Comment

Remove the two rubber side grips. Remove the two rubber side grips.
  • Remove the two rubber side grips.

Add Comment

Deck the Halls
With tools and Fix Kits
Locate RS-DP-LS switch. Pull upwards on the switch to remove it.
  • Locate RS-DP-LS switch.

  • Pull upwards on the switch to remove it.

Add Comment

Locate the four 8.3 mm Phillips screws on the circuit board and remove them.
  • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

Add Comment

Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board. Be careful with the wires connected to the circuit board itself as they are thin and delicate. When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.
  • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

  • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

  • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

Add Comment

Remove the six buttons one by one by gripping the back of each one and pushing on them from the front. Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.
  • Remove the six buttons one by one by gripping the back of each one and pushing on them from the front.

  • Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.

  • When reinserting the buttons make sure they are in the correct place and oriented correctly.

Add Comment

Remove the left and right shoulder buttons by sliding them out of their respective slots.
  • Remove the left and right shoulder buttons by sliding them out of their respective slots.

Add Comment

Pull the plastic piece out from the bottom of the controller. Pull the plastic piece out from the bottom of the controller.
  • Pull the plastic piece out from the bottom of the controller.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Eric

Member since: 09/26/2012

81 Reputation

3 Guides authored

Team

Cal Poly, Team 1-7, Propen Fall 2012 Member of Cal Poly, Team 1-7, Propen Fall 2012

CPSU-PROPEN-F12S1G7

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 8

All Time: 1,072