Skip to main content

MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

What you need

  1. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement, Optical Drive: step 1, image 1 of 1
    • Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up off the logic board.

  2. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: step 2, image 1 of 1
    • Disconnect the camera cable by pulling its connector away from the socket (toward the optical drive) on the logic board.

  3. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: step 3, image 1 of 1
    • Use the flat end of a spudger to pry the optical drive connector up off the logic board.

  4. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: step 4, image 1 of 2 MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: step 4, image 2 of 2
    • Remove the two Phillips screws securing the AirPort/Bluetooth board housing.

    • Carefully rotate the AirPort/Bluetooth board housing (with AirPort/Antenna cables still attached) out of the lower case.

  5. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: step 5, image 1 of 1
    • Remove the following three Phillips screws securing the optical drive to the upper case:

    • One 4.5 mm Phillips screw securing the optical drive bracket to the upper case near the fan.

    • Two 2.5 mm Phillips screws securing the optical drive to the upper case near the optical drive opening.

  6. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: step 6, image 1 of 1
    • Lift the optical drive near its connector and pull it away from the upper case to remove it from the computer.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 956