Introduction

Use this guide to remove or replace a dented lower case.

  • Shut down and close your computer. Lay it on a soft surface top-side down.

  • Remove the following ten screws:

    • Two 8 mm 5-point Pentalobe screws

    • Eight 2.5 mm 5-point Pentalobe screws

  • The special screwdriver needed to remove the 5-point Pentalobe screws can be found here.

When you say:

Remove the following ten screws:

Two 8 mm 5-point Pentalobe screws

Eight 2.5 mm 5-point Pentalobe screws

Do the 8mm & 2.5mm dimensions refer to the LENGTH of those screws, or the size of the pentalobe? That is, are there other sizes of pentalobe drivers like there are for hex, phillips and torx? When only one dimension is provided, it is usually the socket/driver size, not the screw length, maybe since the length cannot be seen when the screw is installed.

Can I suggest that you clarify your instructions so folks are confident they are only in need of _one_ pentalobe driver?

Nerdily yours,

Larry (whose iPhone 4S can now get through a day without 6 recharges thanks to ifixit.com ;-)

larryleveen - Reply

The 8mm and 2.5mm are the length of the screws. One pentalobe P5 screwdriver suffices for all the screws (P5 is implicitly the size of the pentalobe screw heads).

Michael Welham -

I sourced all the parts from ifixit, plus a magnetic project mat which I found to be very useful for organising the teardown and reassembly.

Allen - Reply

Image 1/1:
  • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Sam Lionheart

Member since: 10/18/2012

266,143 Reputation

1,111 Guides authored

Team

iFixit Member of iFixit

Community

126 Members

5,821 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 25

All Time: 945