Logitech Harmony Companion Button Pad Replacement

Introduction

The buttons on your Companion remote may stop working or become damaged. This guide will show you how to replace the button pad in your remote. All you'll need for this guide is a plastic opening tool and Phillips #0 screwdriver.

What you need

Step 1 Remote Battery

Logitech Harmony Companion Button Pad Replacement, Remote Battery: step 1, image 1 of 1

Hold the remote with the Logitech label toward you.

Edit

Step 2

Push the battery cover upward.

Edit

MY Logitech Harmony smart control does NOT have a battery door. There is absolutely no way to get to any battery HELP

ussscamp - Jul 22, 2020 Reply

Step 3

Logitech Harmony Companion Button Pad Replacement: step 3, image 3 of 3

Use your finger to lift the battery out of the compartment.
When the battery has lifted, push it up to remove it.

Edit

Step 4 Remote Motherboard

Logitech Harmony Companion Button Pad Replacement, Remote Motherboard: step 4, image 1 of 2

Logitech Harmony Companion Button Pad Replacement, Remote Motherboard: step 4, image 2 of 2

Remove the two 5.0 mm Phillips #0 screws.

Edit

Step 5

Use the plastic opening tool to pry open the back cover of the remote.
It is recommended to have the point of the opening tool facing the back of the remote.
Insert the opening tool on each side of the bottom of the remote, and pull up until you hear the cover click open.
Pry the back cover off by sliding the plastic opening tool down each side.

Edit

Step 6

Use the plastic opening tool to remove the motherboard.

Edit

Pay careful attention to how the battery holders (the wires at the top) are positioned before removing, especially the springs which are designed to push the battery out when lifted, but if not carefully reinstalled will not allow the battery click into place.

Tom Scott - May 5, 2020 Reply