Introduction
If one of the six buttons on the base of joystick no longer works, it may be necessary to replace the circuit board.
What you need
-
-
Remove these three Phillips #1 screws:
-
Two 10mm screws.
-
One 7mm screw.
-
-
-
Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.
-
Remove the two 10mm Phillips #1 screws.
-
-
-
-
Flip the joystick upright.
-
Lift up the sliver base cover and feed the loose circuit board through.
-