Introduction

If you just can't find out what is wrong with your disco ball, you will probably need to open it to troubleshoot it. This guide will walk you through the steps to do that.

Parts

No parts required.

Turn the device over, so that the base is on top.
  • Turn the device over, so that the base is on top.

Add Comment

Peel off the piece of metal that is glued to hold the two halves of the base together.
  • Peel off the piece of metal that is glued to hold the two halves of the base together.

  • You may need rubber cement to reapply the piece of metal when reassembling the device.

Add Comment

Unscrew the four 10mm phillips head screws on the bottom of the device. Once the base is removed, the device should look as shown in the picture.
  • Unscrew the four 10mm phillips head screws on the bottom of the device.

  • Once the base is removed, the device should look as shown in the picture.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nick Kaprielian

Member since: 01/14/2014

476 Reputation

4 Guides authored

Team

Cal Poly, Team 17-3, Forte Winter 2014 Member of Cal Poly, Team 17-3, Forte Winter 2014

CPSU-FORTE-W14S17G3

5 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 342