Introduction

Use this guide to remove the speakers from the device.

Parts

No parts required.

Use the spudger to pry out the indicated rubber squares. Use the #0 Phillips screwdriver to take out the revealed screws. Use the #0 Phillips screwdriver to take out the revealed screws.
  • Use the spudger to pry out the indicated rubber squares.

  • Use the #0 Phillips screwdriver to take out the revealed screws.

Add Comment

Carefully lodge the spudger between the face plate and the hinge mechanism. Gently pry the face plate until it releases from place holders. Gently pry the face plate until it releases from place holders.
  • Carefully lodge the spudger between the face plate and the hinge mechanism.

  • Gently pry the face plate until it releases from place holders.

Add Comment

Using a spudger, detach the speakers from their place holders. Using a spudger, detach the speakers from their place holders.
  • Using a spudger, detach the speakers from their place holders.

Add Comment

Using the spudger, pry between the speaker circuit board and base to detach with ease.
  • Using the spudger, pry between the speaker circuit board and base to detach with ease.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Harry Black

Member since: 04/20/2010

56 Reputation

1 Guide authored

Team

Cal Poly, Team 10-44, Garner Spring 2010 Member of Cal Poly, Team 10-44, Garner Spring 2010

CPSU-GARNER-S10S10G44

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 1,427