Kurio Xtreme Back Panel Replacement

You're viewing a previously published version of this guide. View latest version

Nov 19, 2015 - 12:48:00

Nov 19, 2015 - 12:48:00 Nov 19, 2015 - 12:47:53 Oct 26, 2015 - 10:46:40 Oct 26, 2015 - 10:28:54 Oct 21, 2015 - 08:39:17 Oct 20, 2015 - 08:03:06 Oct 19, 2015 - 10:54:05 Oct 18, 2015 - 04:46:45 Oct 18, 2015 - 04:40:35 Oct 18, 2015 - 04:39:21 Oct 18, 2015 - 04:29:51 Oct 18, 2015 - 04:24:45 Oct 18, 2015 - 04:22:52 Oct 18, 2015 - 04:22:07 Oct 18, 2015 - 03:56:43 Oct 16, 2015 - 10:44:21 Oct 16, 2015 - 10:21:54 Oct 16, 2015 - 08:26:54 Oct 16, 2015 - 08:00:16 Oct 14, 2015 - 11:01:00 Oct 14, 2015 - 10:57:41 Oct 14, 2015 - 10:55:04 Oct 14, 2015 - 09:46:22 Oct 14, 2015 - 09:45:51 Oct 14, 2015 - 09:45:43 Oct 14, 2015 - 09:44:24 Oct 14, 2015 - 09:39:45 Oct 14, 2015 - 09:37:33 Oct 14, 2015 - 09:36:45 Oct 14, 2015 - 09:36:21 Oct 14, 2015 - 09:35:42 Oct 14, 2015 - 09:15:54 Oct 14, 2015 - 09:06:51

Newer

Introduction

If the back panel on your Kurio Xtreme is broken, it may not sufficiently protect internal parts and wires. Follow this easy guide to remove the broken back panel so that you can replace it with a new one.

What you need

Step 1 Back Panel

Kurio Xtreme Back Panel Replacement, Back Panel: step 1, image 1 of 1

Remove the rubber case by beginning to peel from one of the top corners and continue peeling until the cover is completely removed.

Step 2

Unscrew the four 4 mm black screws using a Phillips #000 screw driver.
There are two screws on each side of the device (four total).

Step 3

Kurio Xtreme Back Panel Replacement: step 3, image 3 of 3

Insert the plastic opening tool in between the edges of the blue front casing and black back casing.
Slide the plastic opening tool around the perimeter of the device. This may require that you repeatedly run the opening tool up and down the edges of the device.
Be sure not to break any of the plastic clamps along the edges of the device when removing the back cover.
Carefully lift the back panel off of the rest of the device.