Open the battery cover and remove the AA batteries from the camera if any are inserted. Open the battery cover and remove the AA batteries from the camera if any are inserted.
  • Open the battery cover and remove the AA batteries from the camera if any are inserted.

Remove screws using a 00 Phillips-Head screwdriver: Eight (8) 3mm screws on the lower portion of the camera Four (4) on the bottom of the camera
  • Remove screws using a 00 Phillips-Head screwdriver:

    • Eight (8) 3mm screws on the lower portion of the camera

      • Four (4) on the bottom of the camera

      • Four (4) on the inside of the battery cover

    • Four (4) 6mm screws on the sides of the camera (two on each side)

Start from a corner and gently remove the bottom of the camera.
  • Start from a corner and gently remove the bottom of the camera.

    • The cover will easily lift off, so not much pressure is required.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Use a Plastic Opening Tool to remove the back of the camera Use a Plastic Opening Tool to remove the back of the camera
  • Remove the four (4) 3mm screws attaching the LCD screen to the circuit board.

  • Use Tweezers to carefully detach the ribbon cable

    • Use extreme caution on this step, as the ribbon cable is very fragile and can rip very easily.

Open the flash compartment and remove two (2) 3mm screws. Open the flash compartment and remove two (2) 3mm screws. Open the flash compartment and remove two (2) 3mm screws.
  • Open the flash compartment and remove two (2) 3mm screws.

Use a Plastic Opening Tool to carefully remove the top of the camera. Use caution when removing the top of the camera
  • Use a Plastic Opening Tool to carefully remove the top of the camera.

  • Use caution when removing the top of the camera

Remove four (4) 3mm screws from the circuit board underneath the button set. Gently move the circuit board aside. Gently move aside the metal sheet.
  • Remove four (4) 3mm screws from the circuit board underneath the button set.

    • Gently move the circuit board aside.

  • Gently move aside the metal sheet.

  • Use Tweezers to carefully remove the flash button.

    • The button should simply pop out when light pressure is applied.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Olivia Boyna

Member since: 03/03/2015

419 Reputation

3 Guides authored

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 5

All Time: 219