Introduction
This will teach you how to remove the capacitor in your Kodak EasyShare LS743.
What you need
-
-
Slide the orange latch sideways to eject the battery.
-
Remove the battery from the battery slot.
-
-
-
Using a Phillips #00 screwdriver, remove two 5.39 mm screws next to the battery slot.
-
Remove the metal piece holding down the lanyard, then remove the lanyard.
-
-
-
Using a Phillips #00 screwdriver, remove seven screws located on the outside case of the camera.
-
One 6.25 mm screw is located on the top right corner, right to the "OK" button.
-
Four 4.45 mm screws are on the bottom of the camera.
-
Two 2.95 mm screws are on the left side of the camera, above the USB port.
-
-
-
-
Connect the two capacitor wires briefly with a pair of metal tweezers to discharge it. You may see a small spark.
-
Remove 8 screws.
-
2 screws in the front (2X 4.31mm).
-
2 screws on the bottom (2X3.30MM).
-
4 screws in the back (3x 3.33mm, and 1x 4.34mm).
-
-
-
Pull the black latch outward slightly to release the flex cable.
-
Carefully disconnect the orange flex cable.
-