Introduction

This guide give instructions on how to locate the keypad for removal and/or repair.

Flip over the phone and then slide down the back cover with your thumb.
  • Flip over the phone and then slide down the back cover with your thumb.

Add Comment

Lever out the battery from the phone using your thumb.
  • Lever out the battery from the phone using your thumb.

Add Comment

Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.
  • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

Add Comment

Gently pull off hinge cap piece from the the top of the phone.
  • Gently pull off hinge cap piece from the the top of the phone.

Add Comment

Black Friday
Broken doesn't stand a chance.
Using a T6 Torx Screwdriver, remove four 7.62mm screws around the corners of the battery compartment
  • Using a T6 Torx Screwdriver, remove four 7.62mm screws around the corners of the battery compartment

Add Comment

Open the phone and turn it on its side Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame
  • Open the phone and turn it on its side

  • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame

Add Comment

Using your hand, gently pull of the back panel from the bottom half of the phone.
  • Using your hand, gently pull of the back panel from the bottom half of the phone.

Add Comment

Close the phone and place on flat surface
  • Close the phone and place on flat surface

  • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing

  • Be careful when pulling up the board, there is still a ribbon cable on the back of the board

Add Comment

When the board is pulled up, look for the ribbon cable holding the board to the rest of the phone
  • When the board is pulled up, look for the ribbon cable holding the board to the rest of the phone

  • Using a plastic opening tool, slowly detach the ribbon cable connection and pull the board away from the frame

Add Comment

Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool
  • Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Andrew

Member since: 10/04/2010

58 Reputation

1 Guide authored

Team

Cal Poly, Team 4-46, Amido Fall 2010 Member of Cal Poly, Team 4-46, Amido Fall 2010

CPSU-AMIDO-F10S4G46

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 2,079