Introduction
Use this guide to replace the power button, volume buttons, and ambient light sensor.
What you need
-
-
In the following steps, you will use a metal spudger to lift the front panel out from the rear case of your TouchPad.
-
-
-
-
Use the edge of a plastic opening tool to flip up the retaining flap on the control button cable ZIF socket.
-
Pull the control button ribbon cable straight out of its socket on the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.