Introduction

This guide will show you how to replace the front mesh on your Insignia NS-PLTPSP13 speaker.

Parts

No parts required.

Use the tweezers to lift the corner of the mesh until a gap is created.
  • Use the tweezers to lift the corner of the mesh until a gap is created.

Add Comment

Once there is a big enough gap, insert the metal spudger and remove the tweezers.  Move the spudger around the edge of the mesh to remove it. Once there is a big enough gap, insert the metal spudger and remove the tweezers.  Move the spudger around the edge of the mesh to remove it.
  • Once there is a big enough gap, insert the metal spudger and remove the tweezers. Move the spudger around the edge of the mesh to remove it.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matt Mrazik

Member since: 03/22/2017

201 Reputation

2 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 31