Introduction

Sometimes a burning smell can come form the toaster. This could be caused by crumbs stuck in the unit so its suggested that you deep clean the Black and Decker Toast R Oven.

Make sure that the toaster is unplugged before you begin.
  • Make sure that the toaster is unplugged before you begin.

  • Turn the toaster over with its backside face down.

  • Remove the two Phillips #4 1cm screws that attach the side panels.

Add Comment

Pull downwards (towards the bottom of the unit) and outward to remove the side panels. Pull downwards (towards the bottom of the unit) and outward to remove the side panels.
  • Pull downwards (towards the bottom of the unit) and outward to remove the side panels.

Add Comment

Remove the metal vent piece that is below the door.
  • Remove the metal vent piece that is below the door.

  • This should slide off easily once both of the side panels are removed.

Add Comment

Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.
  • Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.

Add Comment

Remove the crumb tray (the bottom, metal panel) from the toaster unit.
  • Remove the crumb tray (the bottom, metal panel) from the toaster unit.

Add Comment

Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.
  • Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.

Add Comment

Remove the knobs by pulling them upward; they should slide right off.
  • Remove the knobs by pulling them upward; they should slide right off.

  • When placing the knobs back on the unit, make sure the semicircle notch fits correctly in the hole so that the knobs don't fall off.

Add Comment

Unhook the bottom of the the display panel from the toaster unit.
  • Unhook the bottom of the the display panel from the toaster unit.

  • It will be a little tough to pry off, but don't be afraid to be forceful. You can use your hands, or pliers, to bend the metal piece backwards.

Add Comment

Begin to detach the back panel from the toaster unit.
  • Begin to detach the back panel from the toaster unit.

  • Then, unhook the rest of the display panel.

  • This will also be a little tough to get off, but don't be afraid to be forceful.

Add Comment

Now, you can clean the outside units of the toaster oven.
  • Now, you can clean the outside units of the toaster oven.

Add Comment

Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.
  • Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.

Add Comment

Finish removing the outside cover by lifting the lid upward.
  • Finish removing the outside cover by lifting the lid upward.

Add Comment

Remove the four Phillips #4 1 cm screws from the back of the unit.
  • Remove the four Phillips #4 1 cm screws from the back of the unit.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonathan

Member since: 09/18/2012

105 Reputation

5 Guides authored

Team

Cal Poly, Team 2-10, Propen Fall 2012 Member of Cal Poly, Team 2-10, Propen Fall 2012

CPSU-PROPEN-F12S2G10

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 4

Past 30 Days: 22

All Time: 7,117