Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

A broken light on a Hover-1 XLS bike is a safety hazard, especially if you use the bike when dark. Do not ride the bike with a broken tail light.

Parts

No parts specified.

  1. Remove the seat by removing the six 16mm screws with a Phillips #2 screwdriver. Remember that the seat is still connected by the wiring once you unscrew it.  Pulling too hard can damage the connector.
    • Remove the seat by removing the six 16mm screws with a Phillips #2 screwdriver.

    • Remember that the seat is still connected by the wiring once you unscrew it. Pulling too hard can damage the connector.

  2. Disconnect the wires by pushing the levers on either side of the connector and on top. Remove the seat from the bike. Remove the seat from the bike.
    • Disconnect the wires by pushing the levers on either side of the connector and on top.

    • Remove the seat from the bike.

  3. Android Fix Kits

    A new screen or battery is one kit away.

    Shop Now

    Android Fix Kits

    A new screen or battery is one kit away.

    Shop Now
  4. Use a Phillips #2 screwdriver to remove the four 10mm screws on the bottom of the back seat.
    • Use a Phillips #2 screwdriver to remove the four 10mm screws on the bottom of the back seat.

  5. Pull the light from behind the bottom of the seat frame.  Pull the wiring all the way through. Pull the light from behind the bottom of the seat frame.  Pull the wiring all the way through.
    • Pull the light from behind the bottom of the seat frame. Pull the wiring all the way through.

Christian Roberts

Member since: 01/24/2019

242 Reputation

1 Guide authored

Team

Cal Poly, Team S1-G2, White Winter 2019 Member of Cal Poly, Team S1-G2, White Winter 2019

CPSU-WHITE-W19S1G2

3 Members

6 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 79