Introduction

This guide will walk you through the process of replacing a malfunctioning motherboard in a Hott T725-8G.

Carefully remove the black electrical tape connecting the motherboard to the ribbon wire.
  • Carefully remove the black electrical tape connecting the motherboard to the ribbon wire.

Add Comment

Squeeze both sides of the protector over the ribbon wire to release it. Use the tweezers to gently remove the ribbon wire from the holder. Repeat steps for all three ribbon wires shown.
  • Squeeze both sides of the protector over the ribbon wire to release it.

  • Use the tweezers to gently remove the ribbon wire from the holder.

  • Repeat steps for all three ribbon wires shown.

Add Comment

Use the #000 Phillips screw driver to remove all three 2.2mm screws attached to the mother board. Use the #000 Phillips screw driver to remove all three 2.2mm screws attached to the mother board. Use the #000 Phillips screw driver to remove all three 2.2mm screws attached to the mother board.
  • Use the #000 Phillips screw driver to remove all three 2.2mm screws attached to the mother board.

Add Comment

Conclusion

You are now able to remove the motherboard.

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jason Dorsey

Member since: 10/20/2016

115 Reputation

1 Guide authored

Team

UMass Dartmouth, Team 6-2, Martin Fall 2016 Member of UMass Dartmouth, Team 6-2, Martin Fall 2016

UMASSD-MARTIN-F16S6G2

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 80