Fix Your Stuff Community Store

Hoover T-Series WindTunnel Pet UH70102 Belt Replacement

Introduction

This guide is intended to help you replace the belt on your vacuum. Please see the troubleshooting guide to determine if this needs replacing. Begin by removing the brush roll.

What you need

  1. Hoover T-Series WindTunnel Pet UH70102 Belt Replacement, Brush Roll: step 1, image 1 of 3 Hoover T-Series WindTunnel Pet UH70102 Belt Replacement, Brush Roll: step 1, image 2 of 3 Hoover T-Series WindTunnel Pet UH70102 Belt Replacement, Brush Roll: step 1, image 3 of 3

    • Push the red release lever to the right.

    • Turn the red switch counterclockwise.

    • Tilt the bottom of the plastic tray out towards you and pull it off the vacuum.

  3. Hoover T-Series WindTunnel Pet UH70102 Belt Replacement: step 2, image 1 of 1

    • Pull the brush roll out of vacuum.

    • Remove the belt from brush roller

  4. Hoover T-Series WindTunnel Pet UH70102 Belt Replacement, Belt: step 3, image 1 of 3 Hoover T-Series WindTunnel Pet UH70102 Belt Replacement, Belt: step 3, image 2 of 3 Hoover T-Series WindTunnel Pet UH70102 Belt Replacement, Belt: step 3, image 3 of 3

    • Locate the belt to the right of where the brush roll was.

    • Remove the belt by pulling the bottom off of the pin.

Author

with 3 other contributors

Sophia Stockburger

Member since: 01/22/18

566 Reputation

5 Guides authored

Badges: 7

+4 more badges

Team

Cal Poly, Team S11-G2, Banghart Winter 2018 Member of Cal Poly, Team S11-G2, Banghart Winter 2018

CPSU-BANGHART-W18S11G2

5 Members

9 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 7

Past 30 Days: 24

All Time: 2,464