Hoover T-Series WindTunnel Pet UH70102 Belt Replacement
Sophia Stockburger and 3 other contributors
Last updated on Oct 25, 2019
Views: 3.4K
View statistics:
- Past 24 Hours:
- 4
- Past 7 Days:
- 31
- Past 30 Days:
- 112
- All Time:
- 3,369
Comments: 1
1 comment on steps.
Completed: 1 2
1 person has marked this guide "completed." Will you be next?
2 people have marked this guide "completed." Including you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Introduction
Go to step 1 ↓This guide is intended to help you replace the belt on your vacuum. Please see the troubleshooting guide to determine if this needs replacing. Begin by removing the brush roll.
What you need
Tools
-
-
-
Push the red release lever to the right.
-
Turn the red switch counterclockwise.
-
Tilt the bottom of the plastic tray out towards you and pull it off the vacuum.
Ask FixBot
-
-
-
-
-
-
Remove the belt that's to the right of where the brush roll was by pulling the bottom off of the pin.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Cal Poly, Team S11-G2, Banghart Winter 2018 Member of Cal Poly, Team S11-G2, Banghart Winter 2018
CPSU-BANGHART-W18S11G2
5 Members
60 Guides authored
