Introduction

Use this guide to replace the brush in the head of the vacuum.

Place the vacuum on its back.
  • Place the vacuum on its back.

  • On the bottom right side, push the red lever to the left.

  • Remove the plastic cover.

Add Comment

Grab the red switch under the brush and push left.
  • Grab the red switch under the brush and push left.

  • Then remove the plastic base plate.

Add Comment

  • Use a Phillips #1 screwdriver to remove the two screws on the right side of the brush.

Add Comment

  • Remove the two screws on the left side of the brush.

Add Comment

  • Pull the clear plastic away from the head of the vacuum.

  • Slide the belt off the metal rod with your finger.

  • Pull the brush free.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Erik Ingels

Member since: 01/18/2018

193 Reputation

2 Guides authored

Team

Cal Poly, Team S12-G4, Banghart Winter 2018 Member of Cal Poly, Team S12-G4, Banghart Winter 2018

CPSU-BANGHART-W18S12G4

5 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 47