Introduction

Brush rolls are made to move at high speeds in order to pick up dirt from carpet and wood floors. Sometimes the brush roll can get clogged or break. Follow this guide for brush roll replacement.

Parts

No parts required.

Press grey release button on stick vacuum to release vacuum head. Press grey release button on stick vacuum to release vacuum head.
  • Press grey release button on stick vacuum to release vacuum head.

Add Comment

Locate the circular black turn switch, which is in the upper right corner of the backside of the vacuum head Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the "locked" symbol to the "unlocked" symbol Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the "locked" symbol to the "unlocked" symbol
  • Locate the circular black turn switch, which is in the upper right corner of the backside of the vacuum head

  • Using a metal spudger, place the tool in the indent of the circular turn switch and turn it from the left to the right or from the "locked" symbol to the "unlocked" symbol

Add Comment

Flip the vacuum head over so that the wheels and screws are facing you. Using a PH #1 screw driver, remove the four 15mm screws from each corner of the backside of the vacuum head.
  • Flip the vacuum head over so that the wheels and screws are facing you.

  • Using a PH #1 screw driver, remove the four 15mm screws from each corner of the backside of the vacuum head.

Add Comment

Locate the two wheels in the upper half of the vacuum head and remove them by sticking the metal spudger tool underneath the wheel and pushing it towards you until it pops out. Remove the two 15mm screws located under the wheels with a PH #1 screw driver. Remove the two 15mm screws located under the wheels with a PH #1 screw driver.
  • Locate the two wheels in the upper half of the vacuum head and remove them by sticking the metal spudger tool underneath the wheel and pushing it towards you until it pops out.

  • Remove the two 15mm screws located under the wheels with a PH #1 screw driver.

Add Comment

Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated
  • Using a firm grip, pull the two halves of the vacuum head away from each other until they are completely separated

Add Comment

Remove brush from inside the vacuum head.
  • Remove brush from inside the vacuum head.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

katia zubieta

Member since: 09/11/2017

413 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 16

All Time: 67