Introduction

If your motherboard gets broken by a bad fall or damage while replacing another part it will need to be replaced. Please note that all data is on the motherboard so you will lose your data.

Remove these two 3mm screws using a PH00 Screwdriver
  • Remove these two 3mm screws using a PH00 Screwdriver

Add Comment

Use the blue plastic opening tool to gently pry the back case off
  • Use the blue plastic opening tool to gently pry the back case off

Add Comment

Deck the Halls
With tools and Fix Kits
Unsolder these wires from the motherboard, it is a good idea to label these wires as you remove them according to the picture to the left.
  • Unsolder these wires from the motherboard, it is a good idea to label these wires as you remove them according to the picture to the left.

Add Comment

Remove contact strips by lifting gently on the clip indicated in this picture, then pulling strip out of the clip.
  • Remove contact strips by lifting gently on the clip indicated in this picture, then pulling strip out of the clip.

Add Comment

Remove the 3.5mm screws located at these locations shown on the picture by using the PH00 screwdriver.
  • Remove the 3.5mm screws located at these locations shown on the picture by using the PH00 screwdriver.

Add Comment

Gently lift the motherboard out of the tablet, make sure no wires are still caught or attached while you lift the motherboard.
  • Gently lift the motherboard out of the tablet, make sure no wires are still caught or attached while you lift the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brandon Snodgrass

Member since: 01/29/2015

410 Reputation

4 Guides authored

Team

Clemson, Team 15-8, Shirley Winter 2015 Member of Clemson, Team 15-8, Shirley Winter 2015

CLEM-SHIRLEY-W15S15G8

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 207