Introduction

This guide demonstrates how to remove and replace the volume buttons of an HP eStation Zeen in order to preserve the function of the device.

Use a metal spudger to remove the four screw caps. Remove the four 6 mm screws using a Philips #0 screwdriver. Remove the four 6 mm screws using a Philips #0 screwdriver.
  • Use a metal spudger to remove the four screw caps.

  • Remove the four 6 mm screws using a Philips #0 screwdriver.

Add Comment

Insert a plastic opening tool and slide it along the edge to open the back panel. Lift the back panel away from the device. Lift the back panel away from the device.
  • Insert a plastic opening tool and slide it along the edge to open the back panel.

  • Lift the back panel away from the device.

Add Comment

Disconnect the battery clip with a plastic opening tool.
  • Disconnect the battery clip with a plastic opening tool.

    • Be gentle as the connector is fragile.

Add Comment

Remove the two 6 mm screws using a Philips #0 screwdriver.
  • Remove the two 6 mm screws using a Philips #0 screwdriver.

Add Comment

Pull the ribbon from the board.
  • Pull the ribbon from the board.

    • Be gentle as the ribbon is fragile.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

dalton hale

Member since: 09/26/2016

401 Reputation

4 Guides authored

Team

USF Tampa, Team 16-4, Eyestone Fall 2016 Member of USF Tampa, Team 16-4, Eyestone Fall 2016

USFT-EYESTONE-F16S16G4

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 4

All Time: 69