Introduction

After following the troubleshooting procedures and the device still has no sound it may be time to replace the speaker.

Remove the rubber screw caps using a metal spudger. Remove the two 6mm screw using a Phillips #0 screwdriver. Remove the two 6mm screw using a Phillips #0 screwdriver.
  • Remove the rubber screw caps using a metal spudger.

  • Remove the two 6mm screw using a Phillips #0 screwdriver.

Add Comment

Unclip each side by inserting the plastic opening tool and slide it along the edges. Remove the back panel by lifting the panel away from the device. Remove the back panel by lifting the panel away from the device.
  • Unclip each side by inserting the plastic opening tool and slide it along the edges.

  • Remove the back panel by lifting the panel away from the device.

Add Comment

Disconnect battery clip.
  • Disconnect battery clip.

  • The clip is very fragile.

Add Comment

Disconnect the speaker wires from the terminal using a plastic opening tool.
  • Disconnect the speaker wires from the terminal using a plastic opening tool.

  • Be careful the plastic connector is fragile

Add Comment

Remove the two 6mm screws using a Phillips #0 screwdriver.
  • Remove the two 6mm screws using a Phillips #0 screwdriver.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jack Clark

Member since: 09/26/2016

101 Reputation

1 Guide authored

Team

USF Tampa, Team 16-4, Eyestone Fall 2016 Member of USF Tampa, Team 16-4, Eyestone Fall 2016

USFT-EYESTONE-F16S16G4

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 3

All Time: 76