Fix Your Stuff Community Store

HP ProOne 600 G1 Prerequisite only

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

Introduction

Back Removal.

What you need

  1. HP ProOne 600 G1 Prerequisite only, Back Removal: step 1, image 1 of 2 HP ProOne 600 G1 Prerequisite only, Back Removal: step 1, image 2 of 2

    • Push the unlock tabs on the back of the monitor in and towards each other while sliding the back cover up.

  2. HP ProOne 600 G1 Prerequisite only: step 2, image 1 of 2 HP ProOne 600 G1 Prerequisite only: step 2, image 2 of 2

    • Loosen the two 1/2" screws , with the T15 Torx Screwdriver, on each side of the stand. Remove stand.

  4. HP ProOne 600 G1 Prerequisite only: step 3, image 1 of 1

    • Take out the single 3/8" screw, with the T15 Torx Screwdriver, from the middle of the backplate.

  5. HP ProOne 600 G1 Prerequisite only: step 4, image 1 of 1

    • Remove the backplate by pulling it back towards you.

    • Small plastic tabs hold in the backplate, pull these up to remove it.

Author

with 3 other contributors

Maxwell Snook

Member since: 10/01/15

221 Reputation

1 Guide authored

Badges: 12

+9 more badges

Team

Cal Poly, Team 1-20, Maness Fall 2015 Member of Cal Poly, Team 1-20, Maness Fall 2015

CPSU-MANESS-F15S1G20

4 Members

12 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 40