Lift the top cover of the scanner. Using a small plastic prying tool, carefully pry the plastic frame surrounding the glass from the printer hood. Pry the side piece from the printer hood.
  • Lift the top cover of the scanner.

  • Using a small plastic prying tool, carefully pry the plastic frame surrounding the glass from the printer hood.

  • Pry the side piece from the printer hood.

  • Pull the frame out.

Add Comment

Using a T10 screwdriver, unscrew the two screws that fasten the frame to the printer hood.
  • Using a T10 screwdriver, unscrew the two screws that fasten the frame to the printer hood.

Add Comment

Pushing the clip behind the cover piece in, pull the cover piece outwards. Pushing the clip behind the cover piece in, pull the cover piece outwards.
  • Pushing the clip behind the cover piece in, pull the cover piece outwards.

Add Comment

There are two screws under where the power button panel was and across the printer slider. Unscrew them with a T10 screwdriver. There are two screws under where the power button panel was and across the printer slider. Unscrew them with a T10 screwdriver.
  • There are two screws under where the power button panel was and across the printer slider. Unscrew them with a T10 screwdriver.

Add Comment

Pull the printed circuit board from the main printer body.
  • Pull the printed circuit board from the main printer body.

  • Unplug the small ribbon cable from the circuit board.

Add Comment

Pull the memory card reader's circuit board out of its slot. Detach the wire harness.
  • Pull the memory card reader's circuit board out of its slot.

  • Detach the wire harness.

Add Comment

Press the clip directly behind the TouchSmart panel. Pull the clip to detach.
  • Press the clip directly behind the TouchSmart panel.

  • Pull the clip to detach.

  • Disconnect the ribbon cable from the TouchSmart panel to detach from the main printer body.

  • Do not hesitate to use force to remove the TouchSmart panel.

Add Comment

Gripping the printer hood, pull upward.
  • Gripping the printer hood, pull upward.

Add Comment

Lift the scanning lid from the lower portion of the printer hood. Lift the scanning lid from the lower portion of the printer hood.
  • Lift the scanning lid from the lower portion of the printer hood.

Remove torx screw on bottom of assembly in corner near touchsmart screen space.

Jeff - Reply

Leaving the ribbon connected, lift the sliding scanner off the track. Pull the ribbon cable out of the slot on the scanner circuit board.
  • Leaving the ribbon connected, lift the sliding scanner off the track.

  • Pull the ribbon cable out of the slot on the scanner circuit board.

  • Insert the scanning piece into the rolling track.

Add Comment

Conclusion

To reassemble the sliding scan piece, follow these instructions in reverse order.

Renee Lamb

Member since: 09/26/2012

187 Reputation

3 Guides authored

Team

Cal Poly, Team 2-11, Propen Fall 2012 Member of Cal Poly, Team 2-11, Propen Fall 2012

CPSU-PROPEN-F12S2G11

4 Members

6 Guides authored

One Comment

Where can i buy the scaning piece? Im from Spain.

Bogdan Cosmin - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 1,147