Parts

No parts required.

Introduction

This guide provides instructions to replace the AC power adapter on an unresponsive HP Officejet Pro 6230 Printer. Even though this is an older model printer, it is wireless: this makes it a perfect candidate for iFixit because most people would throw away an old model printer when it's dead, but since it is wireless, it still has the potential to be used alongside new technology. Because of its age, there are not many online guides to help with repairs.

Image 1/2: Note: If you are unsure where the panel is located, look in the back right corner. The panel has “100-240V~50/60 Hz 700 mA” inscribed on it. Image 2/2: Note: If you are unsure where the panel is located, look in the back right corner. The panel has “100-240V~50/60 Hz 700 mA” inscribed on it.
  • Turn the printer around and locate the back panel for power.

  • Note: If you are unsure where the panel is located, look in the back right corner. The panel has “100-240V~50/60 Hz 700 mA” inscribed on it.

Add Comment

Image 1/1: Note: Rotate the screw counterclockwise to loosen. Keep it in a safe place.
  • Unscrew the 0.8 mm screw holding in the panel using a T6 Torx screwdriver.

  • Note: Rotate the screw counterclockwise to loosen. Keep it in a safe place.

Add Comment

Image 1/1:
  • Remove the HP AC Power Adapter from the slot.

Add Comment

Image 1/1:
  • Locate the blue/green/red wire attached to the back of the adapter.

Add Comment

Image 1/1: Grasp the end of the connector, not the wires, to pull it out.
  • Unplug the current adapter from the wire.

  • Grasp the end of the connector, not the wires, to pull it out.

Add Comment

Image 1/1:
  • Affix the new adapter to the same wire.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Natalie Carmona

Member since: 01/28/2017

101 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 6

Past 30 Days: 21

All Time: 106